IMPORTANT: There are two possible firmware options for this vehicle.
Option 1: TL8 with no takeover
Option 2: TL19 with takeover
Important OEM Remote Starter Information
The TL8 firmware will detect it and will program into convenience only (no immobilizer bypass). The reason for this is to allow aftermarket security to be installed while keeping the factory remote starter active. If you wish to use TL8 firmware to control the remote start sequence, the factory remote starter must be disconnected before programming the DBALL2 as both modules cannot coexist.
The TL8 firmware will only operate if the vehicle is equipped with an OEM Remote Start System which is ENABLED by activating the Toyota/Lexus Enform Remote System in the BCM using a dealer scan tool. The vehicle does not have a physical remote start and if not equipped with an ENABLED OEM remote start system, the TL8 firmware will not program.
OEM Remote Active |
---|
Yes |
Keys to Program |
1 |
Keys to Operate |
0 |
3X Lock Start/Stop * |
Yes / Yes |
Takeover |
Yes |
* Only Applies to RSR |
OEM Remote Active |
---|
Yes |
Keys to Program |
1 |
Keys to Operate |
0 |
3X Lock Start/Stop * |
Yes / Yes |
Takeover |
No |
* Only Applies to RSR |
OEM Remote Active |
---|
Yes |
Keys to Program |
1 |
Keys to Operate |
0 |
3X Lock Start/Stop * |
Yes / Yes |
Takeover |
No |
* Only Applies to RSR |